FULL Kit 89'-94' Subaru Justy 2WD, w/Manual Trans. 15% OFF

This is a set of every item that I currently make for the 1989-94 2WD Subaru Justy with a manual transmission. It is not every bushing on the car, but just every one that I currently produce for it.

***If you have a 1989, double check that you have the same design as shown for the "Top Engine Pitch Stop Small Bushing". 89' is right at the transition to a newer design and some cars may have the older design for that bushing. Let me know if this is the case and I will get you the correct one!

The list of items in this set is as follows...

-Hood/bonnet Prop Rod Bushing

-top engine torque/pitch mount large bushing

-Mk2 top engine torque/pitch mount small bushing

-Mk2 right side engine mount 

-2wd engine/transmission mount bushing

-front strut rod bushings

-front lower control arm bushings

-front & rear sway bar end link bushings

-front sway bar inner mounts

-front sway bar outer mounts

-rear sway bar mounts

-rear sway bar pivot bushings

-rear lower control arm inner bushings

-rear shock bump stops

-rear upper spring seats

-large round shifter bushing

-x6 small shifter bushings

-square shifter bushing

-shift pivot ball set

-exhaust hangers

Made of polyurethane rubber. More durable and crack resistant than OEM rubber. Although polyurethane is still flexible, it is slightly more firm than the factory rubber. This will result in sharper/better handling, but it can also cause a slight increase in vibration transfer.

Lubricating grease is supplied with all bushing orders. All contact surfaces of the new bushings and steel sleeves should be thoroughly lubricated before installation for easier installation, smooth/quiet operation and long bushing life.

Due to the several custom options, nearly all items are made to order. Therefore, there could be up to a 10 business day production time on some orders before they ship.

Please message me if you have any questions about this item fitting your specific vehicle or for any other questions.

Color Disclaimer. The formulation of polyurethane that I use to make bushings is chosen because of its high physical strength properties. An unfortunate downside of this type of polyurethane is that it can darken or discolor over time. Especially if it is exposed to UV light. This discoloration has no affect on physical properties but it only aesthetic. I highly recomend not leaving the bushings exposed to sunlight before they are installed. Obviously once installed, sunlight exposure isn't much of an issue but darkening may still occur.