FULL Kit Subaru XT6, 4WD w/Manual Trans. 10% OFF

This is a set of every item that I currently make for the Subaru XT6, Alcyone VX and Vortex ZZ6 with a manual transmission and 4WD. It is NOT every bushing on the car, but just every one that I currently produce for it.

10% cheaper than buying each piece individually.

The list of items in this set is as follows...

-top engine pitch mount - large end bushing  D1003-SUB-EN  $35

-top engine pitch mount - small end bushing.  D1004-SUB-EN  $10

-front strut rod bushings.  D1008-SUB-SU  $45

-front lower control arm bushings 36mm O.D.  $30

-front sway bar mount bushings.  D1026-SUB-SU  $25

-front sway bar end link Upper bushings.  D1024-SUB-SU
And
-front sway bar end link Lower bushings.  D1027-SUB-SU  $28

-XT6 rear differential mount bushing.  D1034-SUB-DT  $28

-rear mustache bar bushings. 63mm  D1059-SUB-DT  $55

-rear axle beam mount bushings 57mm O.D.  D1060-SUB-DT  $60

-rear trailing arm bushings (for 4 arms) 31mm O.D.  D1061-SUB-SU   $60

-manual shift linkage bushings
     -x2  36mm long tube bushings  $16
     -x1  linkage stud bushing.  D1020-SUB-TR  $10
     -x4  thin linkage bushings.  D1022-SUB-TR  $7

 Total $409

Regarding D1061-SUB-SU
**DO NOT remove the original bushings outer metal shell for the Rear Trailing Arm Bushngs. The new DRW bushings D1061-SUB-SU are made to go INSIDE the original bushings outer metal shell. Only remove the oringinal bushings rubber insert.

Made of polyurethane rubber. More durable and crack resistant than OEM rubber. Although polyurethane is still flexible, it is slightly more firm than the factory rubber. This will result in sharper/better handling, but it can also cause a slight increase in vibration/noise transfer.

Lubricating grease is supplied with all bushing orders. All contact surfaces of the new bushings and steel sleeves should be thoroughly lubricated before installation for easier installation, smooth/quiet operation and long bushing life.

Due to the several custom options, nearly all items are made to order. Therefore, there could be up to a 10 business day production time on some orders before they ship.

Please message me if you have any questions about this item fitting your specific vehicle or for any other questions.

Color Disclaimer. The formulation of polyurethane that I use to make bushings is chosen because of its high physical strength properties. An unfortunate downside of this type of polyurethane is that it can darken or discolor over time. Especially if it is exposed to UV light. This discoloration has no affect on physical properties but it only aesthetic. I highly recomend not leaving the bushings exposed to sunlight before they are installed. Obviously once installed, sunlight exposure isn't much of an issue but darkening may still occur.